Kawasaki 250 Kx 2007
MXA'S 2007 KAWASAKI KX250 RACE TEST
It is entirely possible that the 2007 Kawasaki KX250 is living on borrowed time. Last year, with little or no warning, Kawasaki dropped the KX125 from its lineup. The fact that the KX250 survived into 2007, albeit unchanged, is a testament to the hard-core loyalty of two-stroke fans. Kawasaki doesn't want to abandon riders who are looking for a low-cost, easy-to-maintain, lightweight and snappy race machine. That list of attributes can only be applied to a two-stroke. By comparison, four-strokes are high-cost, hard-to-maintain, heavy and torquey race machines. You don't need to be Sherlock Holmes to know that the days of the KX250 are numbered. If there is a resurgence of two-stroke buyers, it will survive. If not, it will go off life support. As for now, the KX250 is still a vital part of Kawasaki's business. Q:DID KAWASAKI MAKE ANY CHANGES TO THE 2007 KX250? A:Nothing earthshattering. Q:IS THE 2007 KX250 ENGINE FASTER THAN THE 2006 ENGINE? A: That would be an impossibility, because the 2007 KX250 engine is the 2006 KX250 engine. Q:IS IT FAST OR SLOW? A:It is fast. Our test bike made 45.7 horsepower on the dyno. That's right in the middle of the 250cc ballpark. The KX250 produces a very old-school style of power. It is more like the mid-and-up engines of the '80s than the new breed of broad-powerband torquey two-strokes. Q:WHAT IS THE BEST THING ABOUT THE 2007 KX250 ENGINE? A:Kawasaki's gun-and-run powerband leaves no doubt about the rider's responsibilities in motivating the green machine to move. It requires a full-throttle, pedal-to-the-metal, flat-out commitment to go fast on a KX250. This is a race-only engine. There isn't a hint of trailbike sensibility to be found. You can't tool around on the KX250 at half throttle, cruise through the turns, or coast in the switchbacks. Q:WHAT IS THE WORST THING ABOUT THE 2007 KX250 ENGINE? A:The KX250's brutal midrange hit and steady pull from mid-and-up come at the expense of rideability. This is not an easy bike to ride. It takes effort and energy to do things that the YZ250 and RM250 can do without breaking a sweat. Like what? The KX250 can't sneak around an off-camber turn. It doesn't have a smooth enough transition from idle to the midrange to allow that. It doesn't offer the rider the flexibility to slip through switchbacks at half throttle. When the KX250 comes on, it jolts the rear end loose. It doesn't have the light touch needed to tractor across rock-hard terrain; it tries to smoke the knobs off with wheelspin. Q:IS THERE A VALID HOP-UP STRATEGY FOR THE KX250? A:Yes. The best hop-up strategy for a rider of normal talent is to hop it down and on the 2007 KX250 that is what Kawasaki tried to do that by spec'ing a new cylinder head. We have always thought that the KX250 engine would benefit from decreased compression and Kawasaki obviously thought so to. The increased combustion chamber volume mellows the hit a little. Q:DOES THE KX250 HAVE THE BEST TWO-STROKE ENGINE IN THE SPORT? A:No. It is a competitive engine that, in the right hands, gets the job done. We'd rate it below the Yamaha, Suzuki and KTM mills, but ahead of the Honda. Q:WHO MAKES THE BEST KAWASAKI KX250 PIPE? A:James Stewart was the last successful KX250 rider on the AMA circuit, and he used a Pro Circuit pipe. It eliminates the tendency for the KX250 to run flat on top and broadens the powerband by skewing it to a higher rev and longer pull. Q:WHAT ABOUT THE JETTING? A:The jetting is lean. We replaced the 160 main with a bigger 162 and could have gone richer. Here are the stock KX250 jetting specs (our changes are in parentheses): Main Jet: 160 (162) Pilot Jet: 50 Needle: NFTG Clip: 2nd from top Air screw: 1-1/2 turns out Q:WHAT ABOUT THE KX250 GEARING? A:We don't like the stock KX250 gearing and never have. There is a large gap between second and third gear. With the stock 51-tooth sprocket, the KX250 can fall off the pipe with every upshift unless you have it pegged. We added one tooth to the rear sprocket to lessen the gulf between second and third. Q: WHAT ABOUT THE 2006 KX250 SHOWABA FORKS? A:The KX250's Kayaba AOSS forks are decent, but flawed. In low-load situations, they ride fairly high in the stroke. But as soon as the load increases (like on the face of jumps, into G-outs or big whoops), they drop down into their stroke and get harsh. They feel stiff, but they bottom. That's a conundrum, because we think the spring rate is correct. These forks need to be revalved. Q: WHAT WAS OUR BEST FORK SETTING? A: For hard-core racing we recommend this fork setup: Spring rate: 0.44 kg/mm Oil height: 310cc Compression: 12 clicks out Rebound: 10 clicks out Fork leg height: Slide the forks down as far as you dare into the triple clamps until you get the new link. Q:WHAT ABOUT THE REAR SUSPENSION? A: This bike is a pogo stick. The rear drops in and rebounds out and both movements are too quick for our tastes. Additionally, the KX250 sits too high in the rear. The result of the stinkbug rear end is that the head angle is steeper than optimal (and steeper than the offset of the triple clamps can handle). There is no bite from the front tire on the entrance of turns. It works okay in a straight line, but upsets the chassis whenever the rider tries to make directional changes over rough ground. The rear end overpowers the front. Q:WHAT WAS OUR BEST SHOCK SETTING? A:For hard-core racing we recommend this shock setup: Spring rate: 5.2 kg/mm Race sag: 105mm High-compression: 1-3/4 turns out Low-compression: 12 clicks Rebound: 9 clicks Notes: Although you might find clicker settings that will work for specific conditions, the basic problem with the KX250's rear shock is its rising rate and valving. Its dimensions and specs are off the chart. Q:WHAT IS THE ULTIMATE FIX FOR THE REAR SUSPENSION? A:Pro Circuit has designed a $185 shock linkage that changes the leverage ratio to hold the KX250 shock higher in its stroke longer. Stiffening the rising rate makes the KX250's rear suspension feel softer. In action, it feels about one spring rate softer (which is a good thing). Pro Circuit couldn't get away with this leverage ratio if they had to work with the stock seat height (which is already too high), but by lengthening the dog-bone from 126mm to 129mm, the Pro Circuit link lowers the rear of the KX by 18mm. Q:HOW DOES THE 2007 KX250 HANDLE? A:Not a single MXA test rider liked the way the KX250 handled. It castered on the entrance to turns. Why? Because Kawasaki steepened the head angle by a full degree back in 2006, but didn't change the fork offset to feed trail back into the system. The result? No bite on the entrance of turns. Thankfully, the Pro Circuit linkage drops the rear of the KX250 enough to kick the head angle out approximately one degree, which in turn feeds some trail back into the front geometry. In our opinion, this is a flawed chassis. The stinkbug rear end hampers not only the rear suspension, but the handling as well. Q: WHAT ARE THE MUST-HAVE AFTERMARKET PARTS FOR THE 2007 KX250? A:Unfortunately, the KX250 wish list involves something you can't buybetter handlingbut here are the things we would change. Linkage: Without the Pro Circuit link, this bike is a handful. Flywheel weights: Kawasaki offers several different versions. A little weight helps this bike a lot. Front tire: A bike that turns this poorly needs the best possible rubber. Q: WHAT DID WE HATE? A:The hate list: (1) Shifting: Mediocre at best. Missed shifts are part of the package. (2) Shift lever: It feels short and delivers almost no feedback. It is positioned too far inboard to insure solid grip. (3) Gearbox: The stock gearing is too tall (which aggravates the gap between second and third). (4) Clutch: Grabby and vague. (5) Tires: Kawasaki's castering front wheel needs all the help it can getand that doesn't come from the Bridgestone 601 front tire. (6) Handling: This a "turn and stomp" chassis. What is that? When the KX250 turns, the front end steps out so fast that you have to stomp your boot on the ground to drag it back in. Q: WHAT DID WE LIKE? A:The like list: (1) Power: We would have liked more half-throttle solutions to problems, but this is a fun powerband to use when you are fresh. It's more Top-Fuel dragster than torquey motocross bike, but we still thrill at the ability to burn rubber. (2) Handlebars: The aluminum Renthals are nice. (3) Brakes: No complaints. Q: WHAT DO WE REALLY THINK? A:This is a bike built solely for dedicated Kawasaki aficionados. It isn't an everyman's bike. It requires too much work to go fast on it, too much good fortune to get it around turns, and too much antigravity matter to keep the rear suspension from pogo-ing. o
Source: https://motocrossactionmag.com/mxas-2007-kawasaki-kx250-race-test/
Tidak ada komentar:
Posting Komentar